Known Bugs

Listed here is Known Bugs that have been sent to me and I have replicated and confirmed exist. If you think you have a bug please contact me with what the issue is, how you made it happen, and any files related to the problem.

This list is current as of 1/1/2012 so any previous bugs that have been found but not fixed or are in limbo should be emailed to me, I will then add them here.

Each Bug will be listed with it's current status of either:
In Testing
Known and not being fixed
Fixed
Along with the Rev. number it was found in and the Rev. Number it was fixed in.

Bug List

NFS Wizards will occasionally cause Mach3 to crash

Found: Rev #R3.043.056

This was reported as cuasing Mach3 to crash when you open the NFS wizrds, But so far I have tested on Both the E-SS and the PP Driver and have had this only happen while testing for it 1 out of 10 times.

This is currently in testing.

4th Axis Rotation Issue

Found: Rev #R3.043.022 & Rev #R3.043.056

This issue appears when you have the setting "Ang Short Rot on G0" turned on and Issue a code with a A0.0 while A is already at 0
IE:
N10694 G0 X77.000 Z44.000 A184.832
N10695 G0 A0.000
N10696 G0 Z36.622
N10697 G1 Z26.622 A0.000
N10698 G1 X72.333 Z25.955

The second A0.0 will cause the axis to rotate to 360 then back to 0.

The setting for "Rot 360 Rollover" needs to be active for the "Ang Short Rot on G0" to work correctly.

This is currently still in testing.

Feedhold Issue

Found: Rev #3.043.056

Pressing feedhold while running a Gcode and jogging away from the part, then pressing cycle start will cause the Prepatory Move Dialogue to not appear. Issueing a tool change call(Stop spindle, wait for cycle start) will cuase the cycle start command to run the tool change then issue the Prepatory Move Dialogue.

IE:
N10 G90 G80 G21
N20 G0 X0 Y0
N30 G1 Z-10 F500
N40 X50
N50 Y50
N60 X0
N70 Y0
N80 G0 Z10
N90 M30

Fixed in Rev #3.043.057